Applying your decals takes about 5 minutes
Our decals come weeded and pre-taped, so there's no weeding or fussing — just peel and stick. Here's exactly how to get a clean, bubble-free result the first time.
What you'll need
Almost nothing:
- Your decals (they arrive on transfer tape, ready to go)
- A clean rag and a little rubbing alcohol or soapy water
- A squeegee, credit card, or plastic scraper
- A strip of masking tape to line it up straight
Step by step
1. Clean and dry the surface. Wipe down the door or panel with rubbing alcohol or soapy water and let it dry. Remove any wax or road film — vinyl won't stick to a dirty or waxed surface.
2. Position and tape. Hold the decal where you want it, use a level or your eye to line it up straight, and tape one edge down as a hinge so it can't shift.
3. Peel the paper backing. Lift from the hinged edge and slowly peel the paper backing away, leaving the vinyl stuck to the clear transfer tape.
4. Squeegee it down. Starting from the taped edge, press the decal onto the surface with firm overlapping strokes, working from the center outward to push out any air.
5. Remove the transfer tape. Slowly peel the clear transfer tape back at a sharp angle (almost flat against the surface), leaving your lettering on the truck. Give it a final press and you're done.
Pro tips
A few things that make it foolproof:
- Apply in mild temperatures (about 50–90°F) — vinyl is stubborn when it's too cold.
- Work on a clean, dry, smooth surface for the best bond.
- If a bubble sneaks in, poke it with a pin and press it flat.
- Let it sit a few hours before washing the vehicle.
Need a fresh set cut to spec?
Every order ships weeded, taped, and ready to apply — just peel and stick.
Shop all decals →